SEAT BELT WARNING SYSTEM DESCRIPTION
Driver seat belt warning light:
When the driver seat belt is not fastened with the power switch on (IG), the seat belt warning light on the combination meter assembly blinks.
Front passenger seat belt warning light:
When the front passenger seat belt is not fastened with the power switch on (IG), the front passenger seat occupied and driver seat belt fastened, the seat belt warning light on the combination meter assembly blinks.
Seat belt warning buzzer:
When the vehicle is driven at approximately 20 km/h (12 mph) while the driver or front passenger seat belt is not fastened, the seat belt warning buzzer in the combination meter assembly sounds at an interval of 1.2 seconds for 30 seconds. After that, the buzzer sounds at an interval of 0.4 seconds for 90 seconds.
FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Front seat inner belt assembly LH | Informs the airbag sensor assembly of the driver seat belt condition (fastened or unfastened). |
| Front seat inner belt assembly RH | Informs the occupant detection ECU of the front passenger seat belt condition (fastened or unfastened). |
·
Rear occupant classification sensor LH ·
Front occupant classification sensor LH |
Informs the occupant detection ECU of the front passenger seat condition (occupied or unoccupied). |
| Occupant detection ECU | Sends the front passenger seat belt buckle switch signal and occupant detection signal to the airbag sensor assembly. |
| Airbag sensor assembly | ·
Sends the driver seat belt buckle switch signal to the main body ECU (multiplex network body ECU) via CAN communication. ·
Sends the front passenger seat belt buckle switch signal to the combination meter assembly via CAN communication. |
| Main body ECU (multiplex network body ECU) | Sends the driver seat belt buckle switch signal to the combination meter assembly via CAN communication. |
| Skid control ECU (brake booster with master cylinder assembly) | Sends the vehicle speed signal to the combination meter assembly via CAN communication. |
| Hybrid vehicle control ECU | Sends the shift position signal to the combination meter assembly via CAN communication. |