Home › Engine / Hybrid System › 1NZ-FXE INTAKE / EXHAUST › EXHAUST MANIFOLD › from 2017.06
RM2170E _51 Engine / Hybrid System _057008 1NZ-FXE INTAKE / EXHAUST _0277969 EXHAUST MANIFOLD A

1NZ-FXE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 25680 1.REMOVE EGR COOLER ASSEMBLY

Hide 17410 2.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) (w/ Exhaust Heat Recirculation System)

CAUTION:

Perform this procedure when the coolant is not hot.


a.
A267691

Slide the 2 clips and disconnect the 2 heater water hoses.


b.
A267687

Remove the 4 bolts and 4 compression springs and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold (TWC: Front Catalyst) and tail exhaust pipe assembly.


c.

Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 3 exhaust pipe supports.


d.

Remove the 2 gaskets from the front exhaust pipe assembly (TWC: Rear Catalyst) and exhaust manifold (TWC: Front Catalyst).


Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) (w/o Exhaust Heat Recirculation System)

a.
A267686

Remove the 4 bolts and 4 compression springs and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold (TWC: Front Catalyst) and tail exhaust pipe assembly.


b.

Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 3 exhaust pipe supports.


c.

Remove the 2 gaskets from the front exhaust pipe assembly (TWC: Rear Catalyst) and exhaust manifold (TWC: Front Catalyst).


Hide 17167 5.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A267688

Remove the 3 bolts and No. 1 exhaust manifold heat insulator.


Hide 25591 6.REMOVE MANIFOLD SUPPORT BRACKET

a.
A267692

Remove the 4 bolts and manifold support bracket.


Hide 25611A 7.REMOVE NO. 1 EGR PIPE

a.
A267693

Remove the bolt, nut and No. 1 EGR pipe.


b.

Remove the gasket.


Hide 17141 8.REMOVE EXHAUST MANIFOLD (TWC: Front Catalyst)

a.
A268068

Disconnect the wire harness clamp and oxygen sensor connector.


b.
A267694

Remove the 3 bolts, 2 nuts and exhaust manifold.


c.

Remove the exhaust manifold to head gasket.


Hide 17168 9.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A268065

Remove the 3 bolts and No. 2 exhaust manifold heat insulator.