Home › Engine / Hybrid System › 1NZ-FXE INTAKE / EXHAUST › EXHAUST PIPE › from 2017.06
RM2170E _51 Engine / Hybrid System _057008 1NZ-FXE INTAKE / EXHAUST _0277970 EXHAUST PIPE A

1NZ-FXE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 1.DRAIN COOLANT (for Engine) (w/ Exhaust Heat Recirculation System)

Hide 17430 2.REMOVE TAIL EXHAUST PIPE ASSEMBLY

a.
A270241

Remove the 2 bolts and 2 compression springs and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly (TWC: Rear Catalyst).


b.

Remove the tail exhaust pipe assembly from the 2 exhaust pipe supports.


c.

Remove the gasket from the front exhaust pipe assembly (TWC: Rear Catalyst).


Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) (w/ Exhaust Heat Recirculation System)

CAUTION:

Perform this procedure when the coolant is not hot.


a.
A267691

Slide the 2 clips and disconnect the 2 heater water hoses.


b.
A267690

Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold (TWC: Front Catalyst).


c.

Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 3 exhaust pipe supports.


d.

Remove the gasket from the exhaust manifold (TWC: Front Catalyst).


Hide 17410 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) (w/o Exhaust Heat Recirculation System)

a.
A267690

Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold (TWC: Front Catalyst).


b.

Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 3 exhaust pipe supports.


c.

Remove the gasket from the exhaust manifold (TWC: Front Catalyst).