Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › PURGE VALVE(w/ Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057007 1NZ-FXE EMISSION CONTROL _0320450 PURGE VALVE(w/ Canister Pump Module) G

1NZ-FXE EMISSION CONTROL  PURGE VALVE(w/ Canister Pump Module)  INSPECTION  


PROCEDURE

Hide 25860D 1.INSPECT PURGE VALVE (PURGE VSV)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge valve (purge VSV).


b.
U159080C01
0.667,0.76 0.99,0.76 0.99,0.76 1.396,1 false 0.458,1.313 0.677,1.313 0.677,1.313 1.031,1.656 false 0.5,0.677 0.625,0.823 0.125,0.146 10 false E 1.333,0.052 1.646,0.375 0.313,0.323 10 false *a 0.302,1.24 0.427,1.385 0.125,0.146 10 false F
*a Air


Apply battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).

OK:
Measurement Condition Specified Condition
Auxiliary battery voltage applied between terminals 1 and 2 Air flows from port (F)
Auxiliary battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the purge valve (purge VSV).