Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › PURGE VALVE(w/o Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057007 1NZ-FXE EMISSION CONTROL _0320451 PURGE VALVE(w/o Canister Pump Module) A

1NZ-FXE EMISSION CONTROL  PURGE VALVE(w/o Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 25860D 1.INSTALL PURGE VALVE (PURGE VSV)

a.

Install the purge valve (purge VSV).


b.
A275469C03
1.229,3.198 1.333,3.198 1.333,3.198 1.417,3.865 false 1.75,2.083 1.927,2.24 0.177,0.156 10 false *a 2.417,3.313 2.594,3.469 0.177,0.156 10 false *d 1.042,3.094 1.219,3.25 0.177,0.156 10 false *e 1.979,3.875 2.156,4.031 0.177,0.156 10 false *c 1.667,3.448 1.844,3.604 0.177,0.156 10 false *b
*a 2 to 7 mm (0.079 to 0.276 in.)
*b 120°
*c Front
*d Up
*e Paint Mark


Connect the fuel vapor feed hose and slide the clip to secure it.

HINT:

Engage the clip within the area shown in the illustration.



c.

Connect the fuel vapor feed hose.


d.

Connect the wire harness clamp.


e.

Connect the purge valve (purge VSV) connector.