Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › PURGE VALVE(w/o Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057007 1NZ-FXE EMISSION CONTROL _0320451 PURGE VALVE(w/o Canister Pump Module) G

1NZ-FXE EMISSION CONTROL  PURGE VALVE(w/o Canister Pump Module)  INSPECTION  


PROCEDURE

Hide 25860D 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge VSV.


b.
U161796E02
0.677,1.198 0.844,1.198 0.844,1.198 1.25,1.427 false 0.656,0.698 0.958,0.698 0.958,0.698 1.438,0.958 false 0.427,0.625 0.552,0.771 0.125,0.146 10 false E 0.479,1.146 0.604,1.292 0.125,0.146 10 false F 1.458,0.052 1.635,0.208 0.177,0.156 10 false *a

Apply auxiliary battery voltage between the terminals of the purge VSV and check that the following occurs when blowing air into port E.

OK:
Measurement Condition Specified Condition
Auxiliary battery voltage applied between terminals 1 and 2 Air flows from port F
Auxiliary battery voltage not applied between terminals 1 and 2 Air does not flow


Text in Illustration
*a Air

If the result is not as specified, replace the purge VSV.