Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › EMISSION CONTROL SYSTEM(w/o Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057007 1NZ-FXE EMISSION CONTROL _0320445 EMISSION CONTROL SYSTEM(w/o Canister Pump Module) G

1NZ-FXE EMISSION CONTROL  EMISSION CONTROL SYSTEM(w/o Canister Pump Module)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Inspect the hoses and gaskets for scratches, cracks or air/oil leaks from the connecting parts.

HINT:

If the hoses or gaskets are damaged or some of the connections are loose, they may cause an engine stall or malfunction.



Hide 2.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Connect the intelligent tester to the DLC3.


b.
A275062

Disconnect the fuel vapor feed hose from the purge valve shown in the illustration.


c.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


d.

Start the engine.


e.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.


f.

Check that vacuum occurs at the purge valve port.


g.

If vacuum does not occur, check the following items.

HINT:
·

Purge VSV (for canister purge)

·

Clogging in the fuel vapor feed hose connecting the intake manifold and Purge VSV




h.

Exit Active Test mode and reconnect the fuel vapor feed hose.


i.

Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.


j.

Warm up the engine and drive the vehicle.


k.

Confirm that the purge valve opens.

If the result is not as specified, replace the purge valve, wire harness or ECM.