RM2170E
_V1
General
_057001
SPECIFICATIONS
_0277860
1NZ-FXE COOLING
F
SPECIFICATIONS 1NZ-FXE COOLING SERVICE DATA
Exhaust Heat Recirculation System
| Condition
|
Rod Operation
|
| Cold (below approx. 71°C (160°F)) → Warmed up (approx. 80°C (176°F) or more)
|
Rod gradually extends smoothly as the temperature rises
|
Temperature Switch
| Condition
|
Specified Condition
|
| Approximately 20°C (68°F)
|
2.32 to 2.59 kΩ
|
| Approximately 80°C (176°F)
|
0.310 to 0.326 kΩ
|
Thermostat
| Condition
|
Specified Condition
|
| Standard valve opening temperature
|
80 to 84°C (176 to 183°F)
|
| Standard valve lift
|
0.8 mm (0.315 in.) or more at 95°C (203°F)
|
Cooling Fan Motor
| Item
|
Condition
|
Specified Condition
|
| Cooling fan motor
|
20°C (68°F) at 12 V
|
12.2 to 15.7 A
|
Cooling Fan Relay
| Tester Connection
|
Condition
|
Specified Condition
|
| 3 - 5
|
Auxiliary battery voltage is not applied between terminals 1 and 2
|
10 kΩ or higher
|
| 3 - 5
|
Auxiliary battery voltage is applied between terminals 1 and 2
|
Below 1 Ω
|
Water Filler Cap Sub-assembly
| Item
|
Tester Connection
|
Specified Condition
|
| Water filler cap sub-assembly
|
for brand-new cap
|
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
|
| for used cap
|
78.5 kPa (0.8 kgf/cm2, 11.4 psi)
|
Coolant
| Capacity
|
Classification
|
w/ Exhaust Heat Recirculation System:
5.2 liters (5.5 US qts, 4.6 lmp. qts)
w/o Exhaust Heat Recirculation System:
4.5 liters (4.8 US qts, 4 lmp. qts)
|
TOYOTA vehicles are filled with TOYOTA SLLC at the factory. In order to avoid damage to the engine cooling system and other technical problems, only use TOYOTA SLLC or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids).
|