Home › General › SPECIFICATIONS › 1NZ-FXE COOLING › from 2017.06
RM2170E _V1 General _057001 SPECIFICATIONS _0277860 1NZ-FXE COOLING F

SPECIFICATIONS  1NZ-FXE COOLING  TORQUE SPECIFICATIONS  


Water Pump
Part Tightened N*m kgf*cm ft.*lbf
Engine water pump x Timing chain cover sub-assembly 21 214 15

Temperature Switch
Part Tightened N*m kgf*cm in.*lbf
Engine coolant temperature sensor x Heater pipe 8.0 82 71

Thermostat
Part Tightened N*m kgf*cm ft.*lbf
Water inlet with thermostat sub-assembly x Timing chain cover sub-assembly 10 102 7

Exhaust Pipe Gas Control Actuator
Part Tightened N*m kgf*cm in.*lbf
Exhaust pipe gas control actuator case x Exhaust pipe for bolt (A) 5.0 51 44
for bolt (B) 8.5 87 75

Cooling Fan Motor
Part Tightened N*m kgf*cm in.*lbf
Cooling fan motor x Fan shroud 3.9 40 35
Fan x Cooling fan motor 6.3 64 56

Radiator
Part Tightened N*m kgf*cm ft.*lbf in.*lbf
No. 3 radiator hose x Fan shroud 7.5 76 66
No. 2 fan shroud x Radiator assembly 7.0 71 62
radiator support RH and LH x Upper radiator support for bolt (A) 5.5 56 49
for bolt (B) 5.5 56 49
for bolt (C) 13 133 10