Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL PRESSURE REGULATOR(w/o Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0320553 FUEL PRESSURE REGULATOR(w/o Canister Pump Module) A

1NZ-FXE FUEL  FUEL PRESSURE REGULATOR(w/o Canister Pump Module)  REMOVAL  


PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 23280J 2.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.
A338498

Remove the No. 2 fuel suction support from the fuel suction plate sub-assembly.


b.
A338499C03
1.063,0.24 1.177,0.24 1.177,0.24 1.375,0.542 false 0.885,0.167 1.198,0.323 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel suction plate sub-assembly.

NOTICE:

Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel suction plate sub-assembly.



c.
A148186C12
1.583,0.646 1.583,0.427 1.583,0.427 0.625,0.427 false 0.927,1.396 0.927,0.427 false 0.427,0.344 0.604,0.479 0.177,0.135 10 *1
*1 O-ring


Remove the 2 O-rings from the fuel pressure regulator assembly.