Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL PUMP(w/ Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0320554 FUEL PUMP(w/ Canister Pump Module) G

1NZ-FXE FUEL  FUEL PUMP(w/ Canister Pump Module)  INSPECTION  


PROCEDURE

Hide 23220A 1.INSPECT FUEL PUMP WITH FILTER ASSEMBLY

a.
A288171E01
1.298,1.033 1.468,1.190 0.170,0.158 10 1 2.02,1.033 2.190,1.190 0.170,0.158 10 2 1.596,0.554 1.387,1.01 false 1.829,0.554 2.037,1.01 false

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump with filter assembly.



b.

Check the operation.

i.

Apply auxiliary battery voltage to both terminals. Check that the fuel pump with filter assembly operates.

NOTICE:
·

Perform this test within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump with filter assembly as far away from the auxiliary battery as possible.

·

Always switch the voltage on and off at the auxiliary battery side, not the fuel pump with filter assembly side.



If the fuel pump with filter assembly does not operate, replace the fuel pump with filter assembly.