23220A
1.INSTALL FUEL PUMP WITH FILTER ASSEMBLY
Perform "Inspection After Repair" after replacing the fuel pump with filter assembly.
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump with filter assembly.
Connect the fuel pump harness connector.
Engage the 5 claws to install the fuel pump with filter assembly to the fuel filter.
Make sure that the O-ring is not cut or pinched during the installation.
Engage the claws securely.
Do not remove the suction filter.
Engage the 2 claws to install the No. 1 fuel suction support.
Engage the 2 claws to install the fuel filter and fuel pump with filter assembly to the No. 1 fuel sub-tank.
Align the groove of the suction filter hose with the cutout of the No. 1 fuel sub-tank and install the suction filter hose.
Do not apply excessive force to the fuel tube or the fuel suction plate sub-assembly.
Connect the fuel pump harness connector.
83320
2.INSTALL FUEL SENDER GAUGE ASSEMBLY