Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL PUMP(w/o Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0320557 FUEL PUMP(w/o Canister Pump Module) G

1NZ-FXE FUEL  FUEL PUMP(w/o Canister Pump Module)  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.
A338513C02
1.156,0.99 1.573,0.573 true 2.26,1.021 1.854,0.583 true 2.26,1.052 2.417,1.25 0.156,0.198 10 false 1 1.052,1.021 1.208,1.219 0.156,0.198 10 false 2 0.135,0.125 0.333,0.323 0.198,0.198 10 false *a
*a Component without harness connected
(Fuel Pump)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check the operation.

i.

Apply auxiliary battery voltage to both terminals. Check that the fuel pump operates.

NOTICE:
·

Perform this test within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump as far away from the auxiliary battery as possible.

·

Always switch the voltage on and off at the auxiliary battery side, not the fuel pump side.



If the fuel pump does not operate, replace the fuel pump.