Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0320556 FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module) G

1NZ-FXE FUEL  FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module)  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.
A307401C02
0.115,0.094 2.052,1.563 1.938,1.469 1.188,4.083 0.51,4.083 true 2.417,2.25 1.365,2.25 false 0.208,0.146 0.729,0.542 0.521,0.396 10 false *a 0.354,4 0.677,4.229 0.323,0.229 10 false E 1.177,2.167 1.396,2.396 0.219,0.229 10 false F
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Check that the float moves smoothly between F and E.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Float Level Specified Condition
1 - 2 F 13.5 to 16.5 Ω
Between F and E 13.5 to 414.5 Ω (Gradually changes)
E 405.5 to 414.5 Ω


If the value is not as specified, replace the fuel sender gauge assembly.