Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0320559 FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module) G

1NZ-FXE FUEL  FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module)  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

CAUTION:

Perform the inspection in a well-ventilated area.

Do not perform the inspection near an open flame.


a.
A339040C03
1.49,2.26 2.417,2.26 false 0.594,4.094 1.219,4.094 false 0.396,1.531 0.615,1.208 true 1.115,1.208 1.344,1.552 true 0.177,0.135 0.49,0.292 0.313,0.156 10 false *a 1.375,2.177 1.531,2.375 0.156,0.198 10 false F 0.49,4.021 0.646,4.219 0.156,0.198 10 false E 1.385,1.521 1.542,1.719 0.156,0.198 10 false + 0.333,1.49 0.49,1.688 0.156,0.198 10 false -
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Check that the float moves smoothly between F and E.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Float Level Specified Condition
1 - 2 F 13.5 to 16.5 Ω
Between F and E 13.5 to 414.5 Ω (Gradually changes)
E 405.5 to 414.5 Ω


If the result is not as specified, replace the fuel sender gauge assembly.