1.CUSTOMIZE LIGHTING SYSTEM (EXT)
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
The following items can be customized.
Customizing with the GTS
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Light Control.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Response Time*1, *2 | Changes the delay timing of lighting the taillights when going into a tunnel when the light control switch is in the AUTO position | Normal | Normal or Long | Main Body ECU (Multiplex Network Body ECU) |
| Disp Ex ON Sen*1 | Changes the ambient brightness level required to dim the display lights such as the indicator lights of the combination meter, A/C indicator light and clock.*A | NORMAL | LIGHT2, LIGHT1, NORMAL, DARK1 or DARK2 | Main Body ECU (Multiplex Network Body ECU) |
| Disp Ex OFF Sen*1 | Changes the ambient brightness level required to cancel the dimming of the display lights such as the indicator lights of the combination meter, A/C indicator light and clock.*B | NORMAL | LIGHT2, LIGHT1, NORMAL, DARK1 or DARK2 | Main Body ECU (Multiplex Network Body ECU) |
| Sensitivity*1 | Adjusts the sensitivity of the automatic light control system.*C | Normal | Light2, Light1, Normal, Dark1 or Dark2 | Main Body ECU (Multiplex Network Body ECU) |
*1: w/ Automatic Light Control
*2: w/o Daytime Running Light
The sensitivity adjustment may be difficult to confirm. Check by driving the vehicle.
*A
*B
*C