Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR › from 2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277930 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide G922E 2.DISCONNECT HYBRID WATER PUMP INLET HOSE

a.
A401776

Slide the hose clip and disconnect the hybrid water pump inlet hose from the inverter water pump assembly.

NOTICE:
·

During removal, make sure not to damage the port of the inverter water pump assembly or the inner surface of the hose.

·

Perform the work by hand. Do not use tools.

·

Put pieces of cloth into the pipes and disconnected hoses or cover the pipes and hoses with plastic bags to prevent foreign matter from entering the inverter water pump assembly and inverter cooling system.

·

Do not apply excessive force to the hoses.




Hide G922F 3.DISCONNECT NO.1 HYBRID WATER PUMP OUTLET HOSE

a.
A401777

Slide the hose clip and disconnect the No. 1 hybrid water pump outlet hose from the inverter water pump assembly.

NOTICE:
·

During removal, make sure not to damage the port of the inverter water pump assembly or the inner surface of the hose.

·

Perform the work by hand. Do not use tools.

·

Put pieces of cloth into the pipes and disconnected hoses or cover the pipes and hoses with plastic bags to prevent foreign matter from entering the inverter water pump assembly and inverter cooling system.

·

Do not apply excessive force to the hoses.




Hide G9040 4.REMOVE INVERTER WATER PUMP ASSEMBLY

a.
A401778

Disconnect the inverter water pump assembly connector.

NOTICE:
To prevent the coolant from entering the inverter water pump assembly connector, perform the following procedure.
·

Wipe off any coolant around the inverter water pump assembly connector before disconnecting it.

·

Apply insulating tape to the connectors of the wire harness and inverter water pump assembly to prevent the entry of coolant.




b.

Remove the 2 bolts and the inverter water pump assembly.

NOTICE:

If the inverter water pump assembly has been struck or dropped, replace it.



Hide G9200 5.REMOVE INVERTER WITH CONVERTER ASSEMBLY

HINT:

Perform this procedure only when replacement of the HV water pump bracket sub-assembly is necessary.


Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>INVERTER WITH CONVERTER>REMOVAL

Hide G9110 6.REMOVE INVERTER BRACKET ASSEMBLY

HINT:

Perform this procedure only when replacement of the HV water pump bracket sub-assembly is necessary.


Click hereEngine / Hybrid System>1NZ-FXE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL

Hide G9031A 7.REMOVE HV WATER PUMP BRACKET SUB-ASSEMBLY

HINT:

Perform this procedure only when replacement of the HV water pump bracket sub-assembly is necessary.


a.
A401779

Disconnect the clamp.


b.

Remove the 2 bolts and the HV water pump bracket sub-assembly.