73240
1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (w/o Occupant Classification System)
for Driver:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 3 | Driver seat belt unfastened | Below 1 Ω |
| 2 - 3 | Driver seat belt fastened | 10 kΩ or higher |
| *a | Component without harness connected
(Front Seat Inner Belt Assembly (for Driver)) |
If the result is not as specified, replace the front seat inner belt assembly (for driver).
for Front Passenger:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M11-3 - B-1 | Always | Below 1 Ω |
| M11-2 - B-3 | Front passenger seat belt unfastened | Below 1 Ω |
| M11-2 - B-3 | Front passenger seat belt fastened | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M9-3 - B-1 | Always | Below 1 Ω |
| M9-2 - B-3 | Front passenger seat belt unfastened | Below 1 Ω |
| M9-2 - B-3 | Front passenger seat belt fastened | 10 kΩ or higher |
| *A | for LHD |
| *B | for RHD |
| *a | Component without harness connected
(Front Seat Inner Belt Assembly (for Front Passenger)) |
If the result is not as specified, replace the front seat inner belt assembly (for front passenger).