Home › Steering › STEERING COLUMN › STEERING PAD SWITCH › from 2017.06
RM2170E _55 Steering _057027 STEERING COLUMN _0278049 STEERING PAD SWITCH A

STEERING COLUMN  STEERING PAD SWITCH  INSTALLATION  


PROCEDURE

Hide 84247A 1.INSTALL STEERING PAD SWITCH LH

a.

Connect the connector to install the steering pad switch LH to the steering pad switch RH.


b.
C378312C02
2.292,0.698 2.573,0.698 false 1.615,2.125 2.01,1.792 2.01,1.792 2.094,1.792 false 2.135,1.708 2.448,1.865 0.313,0.156 10 false *1 1.708,2.458 2.021,2.615 0.313,0.156 10 false *a 2.104,2.677 2.417,2.833 0.313,0.156 10 false *b 2.146,1.219 2.458,1.375 0.313,0.156 10 false *c 2.615,0.615 2.927,0.771 0.313,0.156 10 false *1
*1 Clamp
*a 70 to 85 mm (2.76 to 3.35 in.)
*b 10 mm (0.394 in.) or less
*c 1 to 3 mm (0.0394 to 0.118 in.)
V100135

Front of the Vehicle


Align a new clamp with the groove and install it as shown in the illustration.

NOTICE:

Make sure to install the clamp in the correct direction.



c.

After installation, cut off the excess length of the clamp within the specified range (*c) shown in the illustration.


Hide 2.INSTALL STEERING PAD SWITCH ASSEMBLY

a.

Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.


b.

Install the 2 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


c.

Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.


d.

Install the 2 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


e.

Connect the steering pad switch connector to the spiral cable.


Hide 45130 3.INSTALL HORN BUTTON ASSEMBLY