47547B
1.TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
Temporarily install the front disc brake bleeder plug to the disc brake cylinder.
Fully tighten the front disc brake bleeder plug after bleeding any air left in the system.
31478B
2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
Install the front disc brake bleeder plug cap to the front disc brake bleeder plug.
3.INSTALL PISTON SEAL
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
Install the piston seal to the disc brake cylinder.
Securely install the piston seal into the groove of the disc brake cylinder.
47731
4.INSTALL FRONT DISC BRAKE PISTON
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Piston |
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the inner circumference of a new cylinder boot and the groove of the front disc brake piston.
Install the cylinder boot to the front disc brake piston.
Securely install the cylinder boot into the groove of the front disc brake piston.
Apply a light layer of lithium soap base glycol grease to the entire circumference of a cylinder boot and the front disc brake piston.
Install the front disc brake piston to the disc brake cylinder.
Do not forcibly install the front disc brake piston into the disc brake cylinder.
5.INSTALL CYLINDER BOOT
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Piston |
| *3 | Disc Brake Cylinder |
Install the cylinder boot to the disc brake cylinder as shown in the illustration.
Securely install the cylinder boot into the groove of the disc brake cylinder and front disc brake piston.
Do not damage the cylinder boot.