Be sure to correctly follow the removal and installation procedures for the occupant detection ECU.
89952
1.INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision)
Perform a diagnostic system check (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>DTC CHECK / CLEAR).
89952
2.INSPECT OCCUPANT DETECTION ECU (for Vehicle Involved in Collision)
Perform a diagnostic system check (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>DTC CHECK / CLEAR).
Visually check for defects with the occupant detection ECU.
The defects are as follows:
Cracks in the ECU housing
Dents in the ECU housing
Chips in the ECU housing
Cracks or other damage to the connector
Damage to the serial number
No defects are found.
If any of the defects is found, replace the occupant detection ECU with a new one.