Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM › from 2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0321828 OCCUPANT CLASSIFICATION SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  INITIALIZATION  


NOTICE:

Make sure that the front passenger seat is not occupied before performing the operation.


HINT:

Perform zero point calibration and sensitivity check if any of the following conditions occur:

·

The occupant detection ECU is replaced.

·

Accessories (seatback tray, seat cover, etc.) are installed.

·

The front passenger seat is removed from the vehicle.

·

One of the bolts that is used to install the front passenger seat is removed and reinstalled.

·

The passenger airbag ON/OFF indicator ("ON") comes on when the front passenger seat is not occupied.

·

An occupant classification sensor collision detection DTC is output due to an accident or a collision.



ZERO POINT CALIBRATION AND SENSITIVITY CHECK


a.

Zero point calibration and sensitivity check procedure

i.

Check that both of the following conditions are met:

·

The vehicle is parked on a level surface.

·

No objects are placed on the front passenger seat.



ii.

Adjust the seat position according to the table below.

Adjustment Item Position
Slide Direction Rearmost position
Headrest Height Lowest position
Recline Angle Upright position


iii.

Turn the power switch off.


iv.

Connect the GTS to the DLC3.


v.

Turn the power switch on (IG).


vi.

Turn the GTS on.


vii.

Enter the following menus: Body Electrical / Occupant Detection / Utility / Zero Point Calibration & Sensitivity Check.


viii.

Perform zero point calibration and sensitivity check by following the prompts on the GTS screen.

OK:

"Zero Point Calibration is complete." and "Sensitivity Check is complete." are displayed.


NOTICE:
C320740C01
0.484,0.872 0.654,1.065 0.170,0.193 10 *1 1.475,1.514 0.69,0.976 false
*1 Weight Position


·

Do not allow the weight to come into contact with the seatback when placing it on the seat cushion.

·

Place the weight in the area shown in the illustration.



HINT:
·

When performing sensitivity check, use a solid metal weight (the check result may not appear properly if a liquid weight is used).

·

Refer to the GTS operator's manual for further details.

·

If zero point calibration does not complete, replace the separate type front seat cushion spring assembly.

·

If sensitivity deviates from the specified range, retighten the bolts of the front passenger seat without deforming the seat rail. After performing this procedure, if sensitivity is not within the specified range, replace the separate type front seat cushion spring assembly.