Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM › from 2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0321828 OCCUPANT CLASSIFICATION SYSTEM U

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Occupant Detection / Data List.


f.

Check the values by referring to the table below.

Occupant Detection
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
IG Switch Power switch condition/
ON: Power switch on (IG)
OFF: Power switch off
ON/OFF -
Passenger Buckle SW Passenger side buckle switch/
Set: The seat belt is fastened
Unset: The seat belt is not fastened
NG: Data is not determined
Set/Unset -
Passenger Classification Passenger classification/
AM50: Adult is seated
AF05: Adult is seated
Child: Child is seated
CRS: Child restraint system is installed
OFF: Vacant
AM50/AF05/Child/CRS/OFF -
Sensor Range Info Sensor range information/
OK: Always
OK As sensor range is not set, OK is always displayed
FL Sensor Range Info Front left sensor range information/
OK: Always
OK As front left sensor range is not set, OK is always displayed
RL Sensor Range Info Rear left sensor range information/
OK: Always
OK As rear left sensor range is not set, OK is always displayed
FL Sensor Voltage Front left sensor voltage/
Min.: 0.000 V
Max.: 19.800 V
0.000 to 5.000 V -
RL Sensor Voltage Rear left sensor voltage/
Min.: 0.000 V
Max.: 19.800 V
0.000 to 5.000 V -
FL Sensor Weight Info Front left sensor weight information/
Min.: -10.00 kg (-22.05 lb)
Max.: 20.00 kg (44.09 lb)
-10.00 to 20.00 kg
(-22.05 to 44.09 lb)
-
RL Sensor Weight Info Rear left sensor weight information/
Min.: -10.00 kg (-22.05 lb)
Max.: 30.00 kg (66.13 lb)
-10.00 to 30.00 kg
(-22.05 to 66.13 lb)
-
Total Weight Information Total weight information/
Min.: -40.00 kg (-88.19 lb)
Max.: 100.00 kg (220.46 lb)
-40.00 to 100.00 kg
(-88.19 to 220.46 lb)
-
Number of Present DTC Number of present DTC recorded/
Min.: 0, Max.: 255
0 -
Number of Past DTC Number of past DTC recorded/
Min.: 0, Max.: 255
0 -