Before removing the rear axle beam assembly, make sure to support the front suspension crossmember sub-assembly using a jack or equivalent. If the rear axle beam assembly is removed without the vehicle supported, the front-to-rear weight distribution will become unbalanced and may cause the vehicle to fall off the lift.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISABLE BRAKE CONTROL
3.REMOVE REAR WHEELS
4.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
89407A
5.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)
89516D
6.DISCONNECT SKID CONTROL SENSOR WIRE LH
89516C
7.DISCONNECT SKID CONTROL SENSOR WIRE RH
Perform the same procedure as the LH side.
89516D
8.SEPARATE SKID CONTROL SENSOR WIRE LH
Remove the nut and separate the skid control sensor wire LH.
89516C
9.SEPARATE SKID CONTROL SENSOR WIRE RH
Perform the same procedure as the LH side.
47319F
10.SEPARATE REAR FLEXIBLE HOSE LH
Using a union nut wrench, separate the brake tube while holding the rear flexible hose LH with a wrench.
Do not bend or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting points.
Remove the clip and separate the rear flexible hose LH from the rear axle beam assembly.
47318F
11.SEPARATE REAR FLEXIBLE HOSE RH
Perform the same procedure as the LH side.
42110F
12.LOOSEN REAR AXLE BEAM ASSEMBLY
Loosen the 2 bolts.
| *A | LH Side |
| *B | RH Side |
Do not remove the 2 bolts.
48231B
13.REMOVE REAR COIL SPRING LH
Make sure to place an identification mark on the rear coil spring LH and rear coil spring RH so that they can be reinstalled to their original positions.
Support the spring seat of the rear axle beam assembly using 2 jacks and 2 wooden blocks.
| *1 | Wooden Block | *2 | Jack |
Remove the 2 bolts while holding the 2 nuts and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Since stopper nuts are used, turn the bolts.
Slowly lower the rear axle beam assembly using 2 jacks and 2 wooden blocks, and remove the rear coil spring LH.
Slowly jack up the rear axle beam assembly using 2 jacks and 2 wooden blocks, and temporarily tighten the rear axle beam assembly to the rear shock absorber assemblies LH and RH with the 2 bolts and 2 nuts.
Since stopper nuts are used, turn the bolts.
48231A
14.REMOVE REAR COIL SPRING RH
Perform the same procedure as the LH side.
48259A
15.REMOVE REAR UPPER COIL SPRING INSULATOR LH
48257C
16.REMOVE REAR UPPER COIL SPRING INSULATOR RH
48258C
17.REMOVE REAR LOWER COIL SPRING INSULATOR LH
48258B
18.REMOVE REAR LOWER COIL SPRING INSULATOR RH