1.INSPECT STEERING PAD SWITCH LH
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Steering Pad Switch LH) |
*b | Volume+ |
| *c | Volume- | *d | MODE |
| *e | Seek+ | *f | Seek- |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (AU1) - 1 (EAU) | No switch pushed | 95 to 105 kΩ |
| Seek+ switch pushed | Below 2.5 Ω | |
| Seek- switch pushed | 313 to 345 Ω | |
| Volume+ switch pushed | 980 to 1020 Ω | |
| Volume- switch pushed | 3048 to 3172 Ω | |
| 4 (AU2) - 1 (EAU) | No switch pushed | 95 to 105 kΩ |
| MODE switch pushed | Below 2.5 Ω |
If the result is not as specified, replace the steering pad switch LH.
Check the illumination.
| *a | Component without harness connected
(Steering Pad Switch LH) |
- | - |
Connect an auxiliary battery positive (+) lead to terminal 5 (IL+2) and a negative (-) lead to terminal 2 (IL-2) of the steering pad switch LH connector.
Check that the steering pad switch LH illumination illuminates.
The steering pad switch LH illumination illuminates.
If the result is not as specified, replace the steering pad switch LH.
2.INSPECT STEERING PAD SWITCH RH
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Steering Pad Switch RH) |
*b | Up |
| *c | Down | *d | Right |
| *e | Left | *f | Enter |
| *g | Back | *h | TRIP |
| *i | Terminal-A | - | - |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| z2-1 (HO) - Terminal-A | Always | Below 1 Ω |
| z2-2 (+DP) - z2-7 (EAU) | No switch pushed | 95 to 105 kΩ |
| Enter switch pushed | Below 2.5 Ω | |
| Back switch pushed | 950 to 1050 Ω | |
| z2-3 (+DP2) - z2-7 (EAU) | No switch pushed | 95 to 105 kΩ |
| Left switch pushed | Below 2.5 Ω | |
| Up switch pushed | 313 to 345 Ω | |
| Down switch pushed | 950 to 1050 Ω | |
| Right switch pushed | 2955 to 3265 Ω | |
| z2-4 (TRIP) - z2-7 (EAU) | No switch pushed | 10 kΩ or higher |
| TRIP switch pushed | Below 2.5 Ω | |
| B-1 (EAU) - z2-7 (EAU) | Always | Below 1 Ω |
| B-2 (IL-2) - z2-8 (IL-2) | Always | Below 1 Ω |
| B-3 (AU1) - z2-10 (AU1) | Always | Below 1 Ω |
| B-4 (AU2) - z2-9 (AU2) | Always | Below 1 Ω |
| B-5 (IL+2) - z2-5 (IL+2) | Always | Below 1 Ω |
If the result is not as specified, replace the steering pad switch RH.
Check the illumination.
| *a | Component without harness connected
(Steering Pad Switch RH) |
- | - |
Connect an auxiliary battery positive (+) lead to terminal B-5 (IL+2) and a negative (-) lead to terminal z2-8 (IL-2) of the steering pad switch RH connector.
Check that the steering pad switch RH illumination illuminates.
The steering pad switch RH illumination illuminates.
If the result is not as specified, replace the steering pad switch RH.