Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2017.06
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278203 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

E248380C26
1.448,0.125 1.938,0.417 0.49,0.292 1.323,1.281 0.979,1.698 false 1.708,1.302 1.698,1.75 false 2.104,1.302 2.438,1.698 false 0.167,0.063 0.375,0.26 0.208,0.198 10 false *a 1.594,1.792 2.031,2.063 0.438,0.271 10 false GND 0.917,1.729 1.052,1.927 0.135,0.198 10 false B 1.573,0.198 2.063,0.521 0.49,0.323 10 false A65 2.448,1.74 2.885,2.01 0.438,0.271 10 false B
*a Front view of wire harness connector
(to Stop Light Switch Assembly)


a.

Disconnect the A65 connector from the stop light switch assembly.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A65-1 (B) - A65-3 (GND) Power switch off 11 to 14 V
A65-5 (B) - A65-3 (GND) Power switch on (IG) 11 to 14 V


If the result is not as specified, replace the stop light switch assembly.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A65-3 (GND) - Body ground Always Below 1 Ω



d.
E248381C23
1.5,0.229 1.99,0.521 0.49,0.292 1.75,1.302 2.073,1.813 false 1.948,1.302 2.563,1.635 false 1.51,1.313 1.302,1.781 false 0.198,0.094 0.427,0.271 0.229,0.177 10 false *a 1.635,0.302 2.125,0.615 0.49,0.313 10 false A65 2.01,1.885 2.385,2.073 0.375,0.188 10 false GND 2.656,1.667 3.042,1.854 0.385,0.188 10 false L 1.292,1.833 1.667,2.021 0.375,0.188 10 false L
*a Component with harness connected
(Stop Light Switch Assembly)


Reconnect the A65 connector to the stop light switch assembly.


e.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A65-2 (L) - A65-3 (GND) Power switch off, brake pedal not depressed Below 1 V
A65-2 (L) - A65-3 (GND) Power switch off, brake pedal depressed 11 to 14 V
A65-4 (L) - A65-3 (GND) Power switch on (IG), brake pedal not depressed 11 to 14 V
A65-4 (L) - A65-3 (GND) Power switch on (IG), brake pedal depressed Below 1 V


If the result is not as specified, replace the stop light switch assembly.