Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › from 2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM D

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  OPERATION HISTORY DATA  


OPERATION HISTORY DATA


HINT:

The hybrid vehicle control ECU records inappropriate operations performed by the driver and the number of abnormal conditions that have been input to the ECU as operation history data.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Hybrid Control / Data List.


e.

Enter the menu to view the number of inappropriate operations or controls that have been performed.

HINT:
·

Latest Operation: Among the past occurrences, the number of inappropriate operations or controls that have been performed during the most recent 1 trip detection.

·

Latest Trip: The number of trips after the occurrence of Latest Operation.

·

Operation before Latest: The number of occurrences during the trip previous to the Latest Operation.

·

Trip before Latest: The number of trips after the occurrence of Operation before Latest.



Inappropriate Operation and History Data
Tester Display Count Condition
Shift Gear before READY Shift lever moved with READY indicator blinking
N Range Control in Half Shift Shift position cannot be determined
N Range Control by Busy Shift N position control performed due to frequent shifting operation
Step Accelerator in N Range Accelerator pedal depressed in N position
Auxiliary Battery Low Auxiliary battery voltage below 9.5 V
HV ECU Intermittent Problems Instantaneous open circuit at +B terminal of hybrid vehicle control ECU
MG2 (Motor) Temperature High MG2 temperature rose and HV system overheat was indicated
MG1 (Generator) Temperature High MG1 temperature rose and HV system overheat was indicated
MG2 (Motor) Inverter Temperature High Motor inverter temperature rose and HV system overheat was indicated
MG1 (Generator) Inverter Temperature High Generator inverter temperature rose and HV system overheat was indicated
Main Battery Low Voltage HV battery state of charge dropped below 30%
Resistor Over Heat Precharge resistor overheated
Coolant Heating HV coolant temperature exceeded 65°C (149°F)
Converter Heating Boost converter temperature rose and HV system overheat was indicated
Shift Backward Direction Shifted to R while moving forward or to D or B while moving in reverse
Prevention Control of Staying Engine speed stays in resonance frequency band
Accelerator and Brake Depress Both accelerator and brake pedals depressed
Accelerator Depress when Shift P Position during Ready ON Accelerator pedal depressed in P position when power switch on (READY)