VEHICLE CONTROL HISTORY (HYBRID CONTROL SYSTEM)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Utility / Vehicle Control History.
| GTS Display | Measurement Item | Note |
| Battery Smart Unit Mismatch | Displays if the wrong type of battery voltage sensor is installed. | - |
| Hybrid Battery Cooling Fan Performance Decrement | History of "MAINTENANCE REQUIRED FOR TRACTION BATTERY COOLING PARTS SEE OWNER'S MANUAL" being displayed on the multi-information display. | If "MAINTENANCE REQUIRED FOR TRACTION BATTERY COOLING PARTS SEE OWNER'S MANUAL" is displayed on the multi-information display, perform the following procedures.
·
Make sure the air intake port is not blocked. ·
Make sure there are no gaps between the connecting parts of the ducts. ·
Clean the No. 1 hybrid battery intake filter. Check for entry of foreign matter. Afterwards, clear the DTCs to reset the learning values even if no DTCs are stored. |
| Limit to Charge / Discharge Control Value by Hybrid Battery Temperature High | History of HV battery charge/discharge being restricted
If the temperature of the HV battery becomes approximately 44°C or higher due to high ambient temperature, continuous driving under high load, clogged hybrid battery intake duct, etc., the HV battery current will be restricted. In this case the value of WIN/WOUT will decrease and the engine will stop and start less frequently. |
·
This Vehicle Control History item may be stored if the temperature of the HV battery became high due to certain conditions, such as if the ambient temperature was high or the vehicle was driven continuously under high load. Explain to the customer that this is not a malfunction. |
VEHICLE CONTROL HISTORY (AIRBAG SYSTEM)
A part of the control history can be confirmed using the vehicle control history (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>VEHICLE CONTROL HISTORY).