Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › from 2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0A95-400  High Voltage Fuse  


DESCRIPTION

The hybrid vehicle control ECU estimates the thermal load of the high voltage fuse. If the accumulated thermal load exceeds the threshold, the hybrid vehicle control ECU will store this DTC.

DTC No. INF Code DTC Detection Condition Trouble Area
P0A95 400 Accumulated thermal load of the high voltage fuse estimated by the hybrid vehicle control ECU exceeds the threshold.
(1 trip detection logic)
Service plug grip

CAUTION / NOTICE / HINT

HINT:
·

If the hybrid battery terminal block has been replaced, make sure to perform "High Voltage Fuse Accumulated Load History Reset" and then clear the DTCs.

·

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

(a)

Turn the power switch on (IG) and wait for 5 seconds or more.




PROCEDURE

1.REPLACE SERVICE PLUG GRIP

NEXT

2.PERFORM UTILITY (High Voltage Fuse Accumulated Load History Reset)
2.PERFORM UTILITY (High Voltage Fuse Accumulated Load History Reset)

NEXT

CLEAR DTC (HYBRID CONTROL)
a.

Connect the Techstream to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Clear DTCs.


d.

Clear the DTCs and freeze frame data.


e.

Turn the power switch off.


f.

Disconnect the Techstream from the DLC3.