FREEZE FRAME DATA
Whenever a meter DTC is detected, the meter ECU stores the current vehicle state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body / Combination Meter / DTC.
According to the GTS display, select the trouble code data display with Freeze Frame Data.
Read the Freeze Frame Data recorded when the DTC was set.
| Tester Display | Condition | Displayed Item |
|---|---|---|
| B1503* | Exhaust Heat Management Warning Detected | Trip |
| Elapsed time after turning the power switch on (READY) | ||
| B1507 | Open in turn signal circuit | Trip |
| Elapsed time after turning the power switch on (READY) | ||
| B1508 | Short in turn signal/hazard flasher circuit | Trip |
| Elapsed time after turning the power switch on (READY) | ||
| U0100 | Lost Communication with ECM/PCM "A" | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0129 | Lost Communication with Brake System Control Module | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0131 | Lost Communication with Power Steering Control | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0142 | Lost Communication with Body Control Module "B" | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0151 | Lost Communication with Restraints Control Module | ·
TRIP ·
Elapsed time after power switch on (READY) |
*: w/ Exhaust Heat Recirculation System
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the Freeze Frame Data.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Clear DTCs and Freeze Frame Data (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).