The combination meter assembly communicates with the ECM or hybrid vehicle control ECU, brake booster with master cylinder assembly (skid control ECU), power steering ECU assembly, main body ECU (multiplex network body ECU), and airbag sensor assembly via the CAN communication system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with ECM continues for 2 seconds or more ·
No communication with hybrid vehicle control ECU continues for 3 seconds or more |
·
ECM ·
Hybrid vehicle control ECU ·
CAN communication system ·
Combination meter assembly |
| U0129 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with brake booster with master cylinder assembly (skid control ECU) continues for 2 seconds or more |
·
Brake booster with master cylinder assembly (Skid control ECU) ·
CAN communication system ·
Combination meter assembly |
| U0131 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with power steering ECU assembly continues for 3 seconds or more |
·
Power steering ECU assembly ·
CAN communication system ·
Combination meter assembly |
| U0142 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with main body ECU (multiplex network body ECU) continues for 3 seconds or more |
·
Main body ECU (Multiplex network body ECU) ·
CAN communication system ·
Combination meter assembly |
| U0151 | When IG voltage is 9.5 V or more and the following condition is detected:
No communication with airbag sensor assembly continues for 10 seconds or more |
·
Airbag sensor assembly ·
CAN communication system ·
Combination meter assembly |
Check for DTCs are output.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR
NEXT
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING