1.CUSTOMIZE METER / GAUGE SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
The following items can be customized.
Customizing with the GTS
Connect the GTS to the DLC3.
Turn the ignition switch to ON (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Warning or Display.
Select the setting by referring to the table below.
| Tester Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Key Remind Sound* | Slow | Function to change the cycle of the key remind warning buzzer | Normal, Slow or Fast | Combination meter assembly |
*: This item is displayed on the GTS, but does not apply to vehicles with a Smart Entry and Start System.
| Tester Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| ODO Display Time After IG OFF Setting | 30s | Function to change the ODO display time after the ignition switch is turned off | 30s, 60s, 600s or OFF | Combination meter assembly |