Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/o Wheel Opening Moulding) › from 2017.06
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278207 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

a.
B481389C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly as shown in the illustration.


b.
B481391C01
0,0 0,0 false
V100135

Screw
V100136

Bolt


Remove the 5 screws.


c.

Remove the 3 bolts.


d.
B481392C02
2.344,2.458 2.083,2.188 false 1.396,2.375 1.135,2.104 false 1.615,3.24 1.5,3.115 false 1.667,3.177 1.979,3.333 0.313,0.156 10 false *1 0.969,2.021 1.281,2.177 0.313,0.156 10 false *2 1.917,2.104 2.229,2.26 0.313,0.156 10 false *3
*1 Engine Under Cover
*2 Front Bumper Cover
*3 Front Fender Liner


Pull the engine under cover as shown in the illustration and remove the 2 grommets.


e.
B481394

Disengage the 4 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.

Pull back the side of the front bumper assembly and disconnect each connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



g.
B481398

Using a clip remover, remove the 3 clips.


h.
B481399

Disengage the 2 claws to remove the front bumper assembly as shown in the illustration.