1.INSTALL FRONT BUMPER ASSEMBLY
Engage the 2 claws as shown in the illustration.
Install the 3 clips.
Pull back the side of the front bumper assembly and connect each connector.
Do not apply excessive force when pulling back the front bumper assembly.
Engage the 4 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
| *1 | Engine Under Cover |
| *2 | Front Bumper Cover |
| *3 | Front Fender Liner |
Install 2 new grommets as shown in the illustration.
Install the 3 bolts.
Install the front bumper assembly with the 5 screws.
2.ADJUST FOG LIGHT ASSEMBLY