Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(w/o Wheel Opening Moulding) › from 2017.06
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278208 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


PROCEDURE

Hide 58398J 1.REMOVE NO. 1 FLOOR UNDER COVER

a.
B462024

Using a clip remover, remove the 5 clips and No. 1 floor under cover.


Hide 52461D 2.REMOVE REAR BUMPER CUSHION

a.
B481433

Using a T30 "TORX" socket wrench, remove the 2 rear bumper cushions.


Hide 3.REMOVE REAR BUMPER ASSEMBLY

a.
B481434C02
0.333,0.115 0.49,0.313 0.156,0.198 10 false A 1.604,0.438 1.76,0.635 0.156,0.198 10 false B
V100155

Protective Tape


Apply protective tape around the rear bumper assembly as shown in the illustration.

HINT:
·

As shown in illustration (A), while inserting protective tape into the gap between the rear bumper assembly and the rear combination light assembly, adhere the tape to the upper surface of the rear bumper assembly.

·

As shown in illustration (B), while inserting protective tape into the gap between the rear bumper assembly and the rear combination light assembly, adhere the tape to the rear combination light assembly to cover the area from the tip to the far part of the inner side.




b.

w/o Front Spoiler:

i.
B481435

Using a clip remover, remove the 6 clips.



c.

w/ Front Spoiler:

i.
B483713

Using a clip remover, remove the 8 clips.



d.
B481436

Disengage the 5 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



e.
B481438

Disengage the 2 claws to remove the rear bumper assembly as shown in the illustration.