1.INSTALL REAR BUMPER ASSEMBLY
Engage the 2 claws as shown in the illustration.
Engage the 5 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
w/o Front Spoiler:
Install the rear bumper assembly with the 6 clips.
w/ Front Spoiler:
Install the rear bumper assembly with the 8 clips.
52461D
2.INSTALL REAR BUMPER CUSHION
Using a T30 "TORX" socket wrench, install the 2 rear bumper cushions.
58398J
3.INSTALL NO. 1 FLOOR UNDER COVER
Install the No. 1 floor under cover with the 5 clips.