If ISC learning has not been performed, noise may occur in the hybrid vehicle transaxle assembly.
If noise occurs, initialize the learned values and perform idle learning.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Power train / Engine and ECT / Data List / ISC Learning.
Read the display on the intelligent tester.
| Tester Display | Result | Proceed to |
|---|---|---|
| ISC Learning | Incmpl | A |
| Compl | B |
Turn the power switch off.
A
B
(See pageEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE)
Initialize the learned values and perform idle learning.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION
Confirm that the idle speed is within the standard range.
Engine Idle Speed: 950 to 1050 rpm
Turn the power switch off.
OK
NG
(See pageEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE)