Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › EGR VALVE › from 2017.06
RM2170E _51 Engine / Hybrid System _057007 1NZ-FXE EMISSION CONTROL _0277959 EGR VALVE A

1NZ-FXE EMISSION CONTROL  EGR VALVE  INSTALLATION  


PROCEDURE

Hide 25620 1.INSTALL EGR VALVE ASSEMBLY

HINT:

After replacing the EGR valve assembly, perform the "Inspection After Repair".



a.

Install a new gasket.


b.

Install the EGR valve assembly with the 2 bolts.


c.

Using an E8 "TORX" socket wrench, install the 2 stud bolts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


d.

Connect the No. 1 water by-pass hose.


e.
A266465

Install the EGR valve bracket with the 2 bolts and nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


f.

Connect the clamp and No. 5 water by-pass hose.


g.

Install the wire harness clamp bracket with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


h.
A267673

Connect the 2 connectors and wire harness clamp.


Hide 25612 2.INSTALL NO. 2 EGR PIPE

a.
A268229

Install 2 new gaskets and the No. 2 EGR pipe with the 2 bolts and 2 nuts.

Torque:
Bolt : 10 N*m (102 kgf*cm, 7 ft.*lbf)
Nut : 25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

Make sure to tighten the 4 bolts evenly until the flanges of the EGR pipe assembly contact the installation surfaces.



b.

Connect the clamp and No. 2 water by-pass hose.


c.

Connect the wire harness clamp.