Home › Drivetrain › P510 (HYBRID TRANSMISSION / TRANSAXLE) › OIL PUMP › from 2017.06
RM2170E _52 Drivetrain _057013 P510 HYBRID TRANSMISSION / TRANSAXLE _0334374 OIL PUMP A

P510 HYBRID TRANSMISSION / TRANSAXLE  OIL PUMP  REMOVAL  


PROCEDURE

Hide 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (Integrated Cover Type)

Hide 51442C 2.REMOVE ENGINE UNDER COVER LH (Separated Cover Type)

Hide G1250 3.DISCONNECT MOTOR COOLING PIPE ASSEMBLY

a.
C388181

Remove the bolt and oil cooler tube clamp from the No. 1 transmission control cable bracket.


b.
C388182

Using a 17 mm union nut wrench, disconnect the motor cooling pipe assembly from the union.


Hide 4.REMOVE UNION

a.
C388183

Remove the union from the transmission oil pump cover sub-assembly.


b.
C388184

Remove the O-ring from the union.


Hide 5.REMOVE TRANSMISSION OIL PUMP COVER SUB-ASSEMBLY

a.

Remove the fluid pump cover plug.

HINT:

Perform this procedure only when replacement of the fluid pump cover plug is necessary.


i.
C388185

Remove the fluid pump cover plug from the transmission oil pump cover sub-assembly.


ii.
C388186

Remove the O-ring from the fluid pump cover plug.



b.
C388187

Remove the 4 bolts and transmission oil pump cover sub-assembly from the hybrid vehicle transaxle assembly.

NOTICE:

Be careful not to drop the transmission oil pump drive rotor or transmission oil pump driven rotor.



c.
C388188

Remove the O-ring from the hybrid vehicle transaxle assembly.


Hide 6.REMOVE TRANSMISSION OIL PUMP DRIVEN ROTOR

a.
C388189

Remove the transmission oil pump driven rotor from the hybrid vehicle transaxle assembly.


Hide 7.REMOVE TRANSMISSION OIL PUMP DRIVE ROTOR

a.
C388190

Remove the transmission oil pump drive rotor from the hybrid vehicle transaxle assembly.


Hide 8.REMOVE OIL PUMP DRIVE SHAFT

a.
C388191

Remove the oil pump drive shaft from the hybrid vehicle transaxle assembly.