Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/ Wheel Opening Moulding) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364196 FRONT BUMPER(w/ Wheel Opening Moulding) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(w/ Wheel Opening Moulding)  REMOVAL  


PROCEDURE

Hide 75602A 1.DISCONNECT FRONT FENDER MOULDING SUB-ASSEMBLY LH

a.
B521112

Remove the screw.


b.
B521113C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front fender moulding sub-assembly LH as shown in the illustration.


c.
B521114

Remove the 3 screws.


d.
B521115

Remove the 2 clips.


e.
B521116C01
1.25,2.125 1.396,2.365 false 2.313,2.208 2.458,2.448 false 2,2.833 2.073,3.063 2.073,3.063 1.698,3 false 2.115,3 2.427,3.156 0.313,0.156 10 false *1 1.073,2.052 1.385,2.208 0.313,0.156 10 false *2 2.125,2.156 2.438,2.313 0.313,0.156 10 false *3
*1 Engine Under Cover
*2 Front Bumper Cover
*3 Front Fender Liner


Pull the engine under cover as shown in the illustration and remove the grommet.


f.
B521117

Pull back the edge of the front fender liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

NOTICE:
·

Do not apply excessive force when pulling back the front fender liner LH.


·

To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly LH.




g.

Disengage the clip to disconnect the front fender moulding sub-assembly LH.


Hide 75601A 2.DISCONNECT FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 3.REMOVE FRONT BUMPER ASSEMBLY

a.
B521118C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly as shown in the illustration.


b.
B521119C01
0,0 0,0 false
V100135

Screw
V100136

Bolt


Remove the screw.


c.

Remove the 3 bolts.


d.
B521120

Disengage the 4 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



e.

Pull back the side of the front bumper assembly and disconnect each connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



f.
B481656

Using a clip remover, remove the 3 clips.


g.
B481657

Disengage the 2 claws to remove the front bumper assembly as shown in the illustration.