Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/ Wheel Opening Moulding) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364196 FRONT BUMPER(w/ Wheel Opening Moulding) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(w/ Wheel Opening Moulding)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.
B481658

Engage the 2 claws as shown in the illustration.


b.

Install the 3 clips.


c.

Pull back the side of the front bumper assembly and connect each connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



d.
B521121

Engage the 4 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



e.

Install the 3 bolts.


f.

Install the front bumper assembly with the screw.


Hide 75602A 2.CONNECT FRONT FENDER MOULDING SUB-ASSEMBLY LH

a.
B521122

Engage the clip.


b.

Engage the 4 claws.


c.
B521123C01
1.219,2.188 1.406,2.49 false 2.198,2.271 2.385,2.573 false 1.49,2.74 2.052,3 2.052,3 1.927,2.74 false 2.094,2.938 2.406,3.094 0.313,0.156 10 false *1 1.042,2.135 1.354,2.292 0.313,0.156 10 false *2 2.031,2.219 2.344,2.375 0.313,0.156 10 false *3
*1 Engine Under Cover
*2 Front Bumper Cover
*3 Front Fender Liner


Install a new grommet as shown in the illustration.


d.

Install the 2 clips.


e.

Install the 3 screws.


f.

Install the front fender moulding sub-assembly LH with the screw.


Hide 75601A 3.CONNECT FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.