Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(w/ Wheel Opening Moulding) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364197 REAR BUMPER(w/ Wheel Opening Moulding) A

EXTERIOR PANELS / TRIM  REAR BUMPER(w/ Wheel Opening Moulding)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR BUMPER ASSEMBLY

a.
B481704

Engage the 2 claws as shown in the illustration.


b.
B481702

Engage the 5 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



c.

Install the rear bumper assembly with the 4 clips.


Hide 52461D 2.INSTALL REAR BUMPER CUSHION

a.

Using a T30 "TORX" socket wrench, install the 2 rear bumper cushions.


Hide 58398J 3.INSTALL NO. 1 FLOOR UNDER COVER

a.

Install the No. 1 floor under cover with the 5 clips.


Hide 75606B 4.CONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH

a.
B481755

Engage the 4 claws and 2 clips to connect the quarter outside moulding sub-assembly LH to the rear bumper assembly.


b.

Install the screw.


Hide 75605B 5.CONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 52592 6.INSTALL REAR BUMPER SIDE SEAL LH

a.

Install the rear bumper side seal LH with the 4 clips.


Hide 52591 7.INSTALL REAR BUMPER SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.