Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Front Side) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364198 WHEEL OPENING MOULDING(for Front Side) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Front Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75602A 1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

a.

Remove the 2 screws and clip.

B481716C01
0,0 0,0 false
V100135

Screw
V100136

Clip



b.
B481717C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front fender moulding sub-assembly.


c.
B485650

Remove the 3 screws.


d.
B485651

Remove the 2 clips.


e.
B485661C01
1.25,2.125 1.396,2.365 false 2.313,2.208 2.458,2.448 false 2,2.833 2.073,3.063 2.073,3.063 1.698,3 false 2.115,3 2.427,3.156 0.313,0.156 10 false *1 1.073,2.052 1.385,2.208 0.313,0.156 10 false *2 2.125,2.156 2.438,2.313 0.313,0.156 10 false *3
*1 Engine Under Cover
*2 Front Bumper Cover
*3 Front Fender Liner


Pull the engine under cover as shown in the illustration and remove the grommet.


f.
B481759

Pull back the edge of the front fender liner and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

NOTICE:
·

Do not apply excessive force when pulling back the front fender liner.

·

To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly.




g.
B481718

Disengage the 7 clips to remove the front fender moulding sub-assembly as shown in the illustration.