Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Front Side) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364198 WHEEL OPENING MOULDING(for Front Side) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Front Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75602A 1.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY

a.
B481719

Engage the 7 clips and 4 claws as shown in the illustration.


b.
B485660C01
1.219,2.188 1.406,2.49 false 2.198,2.271 2.385,2.573 false 1.49,2.74 2.052,3 2.052,3 1.927,2.74 false 2.094,2.938 2.406,3.094 0.313,0.156 10 false *1 1.042,2.135 1.354,2.292 0.313,0.156 10 false *2 2.031,2.219 2.344,2.375 0.313,0.156 10 false *3
*1 Engine Under Cover
*2 Front Bumper Cover
*3 Front Fender Liner


Install a new grommet as shown in the illustration.


c.

Install the 2 clips.


d.

Install the 3 screws.


e.

Install the clip.


f.

Install the front fender moulding sub-assembly with the 2 screws.