Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Front Side) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364198 WHEEL OPENING MOULDING(for Front Side) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Front Side)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 76926F 1.INSTALL SIDE MUDGUARD PROTECTOR

a.

Clean the front fender moulding sub-assembly with a non-residue solvent.


b.

Apply primer to the side mudguard protector installation surface of the front fender moulding sub-assembly.

NOTICE:
·

Apply the primer evenly so that there are no uncoated areas.


·

Allow the primer to dry for 3 minutes or more.




c.

Remove the release paper from a new side mudguard protector.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



d.
B481723C01
1.042,1.115 1.25,1.125 1.25,1.125 1.063,1.031 true 2.333,1.063 2.146,0.99 2.146,0.99 2.313,0.917 true 1.26,1.052 1.438,1.208 0.177,0.156 10 true *a 1.958,0.906 2.135,1.063 0.177,0.156 10 true *a 0.281,0.771 0.438,0.969 0.156,0.198 10 false A 3.083,0.885 3.24,1.083 0.156,0.198 10 false B
*a Line


Install the side mudguard protector as shown in the illustration.

NOTICE:
·

Make sure to press the side mudguard protector firmly to securely install it.

·

If the side mudguard protector is not installed within 24 hours after applying primer, reapply primer before installing it.



Standard Measurement:
Area Measurement
A 1.0 mm (0.0394 in.)
B 3.0 mm (0.118 in.)