Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75631R
1.REMOVE NO. 1 ROOF TOP GARNISH
|
Protective Tape |
Apply protective tape around the No. 1 roof top garnish as shown in the illustration.
Using a moulding remover, disengage the claw and guide to remove the No. 1 roof top garnish.
Use the same procedure for the other No. 1 roof top garnish.
75632F
2.REMOVE NO. 2 ROOF TOP GARNISH
|
Protective Tape |
Apply protective tape around the No. 2 roof top garnish as shown in the illustration.
Using a moulding remover, disengage the claw and guide to remove the No. 2 roof top garnish.
63470B
3.REMOVE ROOF RACK ASSEMBLY
Apply protective tape around the roof rack assembly as shown in the illustration.
| *a | Bolt | *b | Screw |
|
Protective Tape | - | - |
Remove the bolt and 2 screws.
Disengage the 5 clips and remove the roof rack assembly.
Remove the 5 clips from the roof rack assembly.
63436B
4.REMOVE NO. 1 ROOF CARRIER SEAL
Remove the No. 1 roof carrier seal.
|
Double-sided Tape | - | - |