Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2018.08
RM2170E _53 Suspension _057019 TIRE PRESSURE MONITORING _0278018 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2177/77  Initialization not Completed  


DESCRIPTION

Initialization is necessary if one of the following occurs:

·

The tire pressure warning ECU and receiver is replaced.

·

A tire pressure warning valve and transmitter is replaced.

·

Tires with different standard tire pressures are installed.

·

The tires are rotated.

·

A new vehicle is delivered.


DTC No. DTC Detection Condition Trouble Area
C2177/77

All conditions below are met:


·

During initialization

·

Tire pressure warning valve and transmitter is not in stop mode

·

Signal is not received from tire pressure warning valve and transmitter for 20 minutes or more

·

Vehicle speed is more than 40 km/h (25 mph) for 20 minutes or more


·

Tire pressure warning valve and transmitter

·

Wire harness or connector

·

Tire pressure warning ECU and receiver



WIRING DIAGRAM

C277675E36
2.813,0.313 4.833,0.833 2.021,0.521 10 false Tire Pressure Warning Valve and Transmitter 0.313,1.063 2.323,1.74 2.01,0.677 10 false Tire Pressure Warning Valve and Transmitter 2.844,1.792 4.875,2.427 2.031,0.635 10 false Tire Pressure Warning Valve and Transmitter 0.302,2.5 2.323,2.927 2.021,0.427 10 false Tire Pressure Warning Valve and Transmitter 5.99,3.604 6.604,4 0.615,0.396 10 false RDA 2.5,3.563 4.156,4.135 1.656,0.573 10 false Main Body ECU (Multiplex Network Body ECU) 2.448,4.729 6.427,4.927 3.979,0.198 10 false Combination Meter Assembly 2.448,5.042 6.885,5.24 4.438,0.198 10 false - Tire Pressure Warning Light 2.469,5.865 3.083,6.063 0.615,0.198 10 false DLC3 2.177,3.563 2.635,3.76 0.458,0.198 10 false G59 1.927,6.917 2.385,7.115 0.458,0.198 10 false G82 4.76,3.948 5.219,4.146 0.458,0.198 10 false 4 4.75,3.49 5.208,3.688 0.458,0.198 10 false 16 5.781,3.49 6.24,3.688 0.458,0.198 10 false 4 5.771,3.948 6.229,4.146 0.458,0.198 10 false 5 1.927,7.083 4.177,7.521 2.25,0.438 10 false Tire Pressure Warning Reset Switch 2.448,6.427 2.906,6.667 0.458,0.24 10 false 2 3.531,6.427 3.99,6.667 0.458,0.24 10 false 1 2.635,6.698 3.094,6.938 0.458,0.24 10 false E 3.229,6.698 3.688,6.938 0.458,0.24 10 false INT 5.76,6.427 6.219,6.667 0.458,0.24 10 false 3 5.698,6.979 6.156,7.219 0.458,0.24 10 false 12 5.677,7.667 7.104,8.073 1.427,0.406 10 false M48 0.563,8.052 2.729,8.448 2.167,0.396 10 false : Radio Waves 0.563,8.438 2.438,8.813 1.875,0.375 10 false : CAN Communication Line 4.333,3.615 4.708,3.885 0.375,0.271 10 false RDA 4.333,4.063 4.688,4.365 0.354,0.302 10 false PRG 5.979,6.552 6.51,6.917 0.531,0.365 10 false CLSW 5.979,7.104 6.51,7.469 0.531,0.365 10 false GND 5.99,4.073 6.51,4.646 0.521,0.573 10 false PRG 5.677,7.844 7.104,8.25 1.427,0.406 10 false Tire Pressure Warning ECU and Receiver

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU and/or one of the valve and transmitters has been replaced.



PROCEDURE

1.CHECK FREQUENCY RECEIVING CONDITION
a.

Check that the vehicle is not located in an area such as described below:

i.

Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.

HINT:

If the vehicle is located in an area such as the one described above, the tire pressure warning light may illuminate after blinking 1 minute due to interfering radio frequencies.



ii.

Devices using similar radio frequencies are used in the vehicle.

OK:

Facilities or devices that use similar radio frequencies are not located in the vicinity of the vehicle.


HINT:

Radio transmissions may be interrupted due to the surroundings, or devices installed by the user.





OK

2.PERFORM INITIALIZATION

NG

CHECK IF ANY DEVICE IS INSTALLED BY USER

2.PERFORM INITIALIZATION

NEXT

3.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)
3.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


f.

Check the values by referring to the table below.

Tire Pressure Monitor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
ID 1 Tire Inflation Pressure ID1 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 2 Tire Inflation Pressure ID2 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 3 Tire Inflation Pressure ID3 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 4 Tire Inflation Pressure ID4 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1

HINT:
·

*1: It may take a few minutes until the values are displayed.

·

When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.



Result:
Result Proceed to
All tire pressure readings are equal to specified values. A
Tire pressure values are not displayed. B




A

END

B