Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2019.07–2020.08
RM2170E _57 Power Source / Network _057033 NETWORKING _0278068 CAN COMMUNICATION SYSTEM U

NETWORKING  CAN COMMUNICATION SYSTEM  FAIL-SAFE CHART  


FAIL-SAFE FUNCTION


a.

When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for each system operates to prevent those systems from malfunctioning.


b.

The following table shows the effects on each system when communication is impossible. (For further details, see the pages for each system.)

Function Control Master System Related Fail-safe Operation Driver Detectable DTC Detection
(ECU that stored DTC)
Air Conditioning Control
·

Corrects engine speed, such as for idle up.

·

Controls outlet air temperature, outlet mode change and airflow volume based on engine coolant temperature signal.

·

Corrects engine coolant temperature map and changes compressor lock judgment value.


Air conditioning amplifier assembly Hybrid vehicle control computer assembly Control is performed based on default coolant temperature of 80°C (176°F). - U0293
(Air conditioning amplifier assembly)
Destination Identification Control
·

Changes air conditioning control pattern according to destination.


Air conditioning amplifier assembly Main body ECU (Multiplex network body ECU) Maintains the latest state. - U0142
(Air conditioning amplifier assembly)
Ambient Temperature Correction Control
·

Switches air conditioning system operation condition and corrects value of displayed ambient temperature according to vehicle speed signal.


Air conditioning amplifier assembly Combination meter assembly Control is performed based on default vehicle speed of 0 km/h (0 mph).
·

Correction level for displayed ambient temperature declines.

·

Correction level for outlet airflow declines.


U0155
(Air conditioning amplifier assembly)
Air Conditioning Eco Mode Control
·

Performs control in Eco mode using B_ECOMI.


Air conditioning amplifier assembly Hybrid vehicle control computer assembly Maintains the latest state (Maintained in normal condition after reset). - U0101
(Air conditioning amplifier assembly)
Door Lock
·

Controls key linked and automatic door lock/unlock function, key confinement prevention function, etc.


Main body ECU (Multiplex network body ECU)
·

Combination meter assembly

·

ECM

·

Hybrid vehicle control computer assembly

·

Smart key ECU assembly (Certification ECU)


·

Speed sensitive automatic lock control does not occur.

·

Shift linked automatic lock control does not occur.

·

Shift linked automatic unlock control does not occur.

·

Automatic lock/unlock cannot be changed.


- U0100
U0101
U0155
(Main body ECU (Multiplex network body ECU))
Illumination Control
·

Turns on the interior lights when the smart key is brought near the vehicle.


Main body ECU (Multiplex network body ECU) Smart key ECU assembly (Certification ECU) Interior lights turn off. - U0327
(Main body ECU (Multiplex network body ECU))
Entry Function/Wireless Control Smart key ECU assembly (Certification ECU) Main body ECU (Multiplex network body ECU) Entry lock/unlock control is not possible. - U0327
(Main body ECU (Multiplex network body ECU))
Drive Torque Control
·

Controls the engine, MG1 and MG2 based on engine information received.


Hybrid vehicle control computer assembly ECM Vehicle drives using only the motor.
·

Displays messages on the multi-information display.

·

MIL illuminates.


U0100
(Hybrid vehicle control computer assembly (HV CPU))
Regenerative Operation
·

Provides maximum amount of regeneration based on cooperative control with the ECB system.


Hybrid vehicle control computer assembly Brake booster with master cylinder assembly (Skid control ECU) Regeneration is prohibited.
·

Displays messages on the multi-information display.

·

MIL illuminates.


U0129
(Hybrid vehicle control computer assembly (HV CPU))
High Voltage Shut Off Control when the vehicle is damaged
·

Receives the SRS collision detection signal and shuts off the system main relays.


Hybrid vehicle control computer assembly Airbag sensor assembly Normal driving. Displays messages on the multi-information display. U0151
(Hybrid vehicle control computer assembly (HV CPU))
HV System Power Processing
·

Monitors whether IG2 is stuck ON based on IG2 information from the Hybrid vehicle control computer assembly.


Hybrid vehicle control computer assembly (HV CPU) Smart key ECU assembly (Certification ECU) (Power management control CPU)
·

Normal driving.

·

Power switch turns off 10 seconds after the vehicle is stopped and shift lever is moved to P.


Displays messages on the multi-information display. U1107
(Hybrid vehicle control computer assembly (HV CPU))
Air Conditioning Control
·

Sends a signal from the air conditioning amplifier assembly to the hybrid vehicle control computer assembly (HV CPU) and from the hybrid vehicle control computer assembly (HV CPU) to the inverter for the air conditioning system.


Air conditioning amplifier assembly Hybrid vehicle control computer assembly Air conditioning cooling operation is stopped. - U0164
(Hybrid vehicle control computer assembly)
Engine Start/Stop Switch (Power Source Mode Change)
·

Using start/stop switch signal as trigger, changes power source mode automatically and requests starter operation when conditions are met.


Smart key ECU assembly (Certification ECU) (Power management control CPU)
·

Main body ECU (Multiplex network body ECU)

·

Combination meter assembly

·

Hybrid vehicle control computer assembly (HV CPU)


None - U0140
U0155
U0293
Smart key ECU assembly (Certification ECU) (Power management control CPU)
Cruise Control
·

Calculates demand drive force to maintain vehicle speed.


Hybrid vehicle control computer assembly Brake booster with master cylinder assembly (Skid control ECU) Cruise control is canceled.
·

Displays messages on the multi-information display.

·

Master warning light turns on.


U0122
(Hybrid vehicle control computer assembly)
Charge Control
·

Performs idle up according to charging request.


Hybrid vehicle control computer assembly Air conditioning amplifier assembly Idle up according to charging request is not performed. Taillights flicker and blower airflow changes. -
Power Steering Control
·

Calculates assist current according to torque sensor value and vehicle speed and drives motor.


Power steering ECU assembly
·

Hybrid vehicle control computer assembly

·

Brake booster with master cylinder assembly (Skid control ECU)


·

Assist force restricted.

·

Drivability degrades (compensation control using steering angle is stopped).


EPS warning light illuminates. U0129
U0293
(Power steering ECU assembly)
Steering Assist Calculation
·

Changes assist force based on vehicle speed.


Power steering ECU assembly Brake booster with master cylinder assembly (Skid control ECU) Assist force restricted. EPS warning light illuminates. U0129
U0293
(Power steering ECU assembly)
Steering Assist Start Judgment Power steering ECU assembly
·

Hybrid vehicle control computer assembly

·

Brake booster with master cylinder assembly (Skid control ECU)


When a communication stop of hybrid vehicle control computer assembly occurs:
·

Assist starts when the vehicle speed is 0.1 km/h (0.06 mph) or more.


When a communication stop of the hybrid vehicle control computer assembly or brake booster with master cylinder assembly (skid control ECU) occurs:
·

Assist force restricted.


EPS warning light illuminates. U0129
U0293
(Power steering ECU assembly)
Assist Map Selection
·

Selects proper assist map according to destination, engine type, etc.


Power steering ECU assembly Hybrid vehicle control computer assembly Default map is used to assist because proper assist map cannot be selected. (Steering feel may be different.) EPS warning light illuminates. C1581
(Power steering ECU assembly)
Steering Assist Compensation Control
·

Provides steering assist with compensation amount based on vehicle speed.


Power steering ECU assembly Brake booster with master cylinder assembly (Skid control ECU) Assist force restricted. EPS warning light illuminates. U0129
(Power steering ECU assembly)
Steering/Steering Angle Sensor Initialization and Zero Point Learning
·

Performs steering/ steering angle sensor initialization and zero point learning.


Power steering ECU assembly
·

Brake booster with master cylinder assembly (Skid control ECU)

·

Spiral cable with sensor sub-assembly (Steering angle sensor)

·

Airbag sensor assembly (built-in type yaw rate sensor)


Steering initialization and zero point learning are not performed. EPS warning light illuminates. U0129
(Power steering ECU assembly)
Entry Function
·

Entry lock/unlock, entry luggage compartment open.

·

Warning.

·

Performs entry illumination (Interior illumination, etc.).


·

Main body ECU (Multiplex network body ECU)

·

Smart key ECU assembly (Certification ECU)


·

Main body ECU (Multiplex network body ECU)

·

Combination meter assembly


Entry unlock is performed again.
·

Entry lock/unlock or entry luggage compartment open does not operate.

·

Warning functions (Key confinement, Key not in vehicle, Key reminder, etc.) do not operate, Key confinement prevention control does not operate.

·

Entry illumination does not operate.


U0327
(Main body ECU (Multiplex network body ECU))
U0142
U0155
(Smart key ECU assembly (Certification ECU))
Wireless Function
·

Locks and unlocks doors, etc. via remote operation.


Main body ECU (Multiplex network body ECU) Smart key ECU assembly (Certification ECU) Wireless lock, unlock and luggage compartment opener do not operate. - U0142
(Smart key ECU assembly (Certification ECU))
Power Switch Backlighting Control
·

Turns on/off power switch illumination linked with interior lights, etc.


Smart key ECU assembly (Certification ECU) Main body ECU (Multiplex network body ECU) Power switch backlighting does not illuminate according to interior lights operation. - U0142
(Smart key ECU assembly (Certification ECU))
Vehicle Speed Display Combination meter assembly Brake booster with master cylinder assembly (Skid control ECU) Speedometer is controlled based on a default vehicle speed of 0 km/h (0 mph).
·

The needle points at 0 km/h (0 mph).

·

Drive monitor calculation is stopped.


U0129
(Combination meter assembly)
HV Indicator Display Combination meter assembly Hybrid vehicle control computer assembly HV indicator turns off. - U0100
(Combination meter assembly)
Airbag
·

Airbag warning light control.


Combination meter assembly Airbag sensor assembly None SRS warning light illuminates. U0151
(Combination meter assembly)
EPS Warning
·

EPS warning light control.


Combination meter assembly Power steering ECU assembly None EPS warning light illuminates. U0131
(Combination meter assembly)
SLIP Warning
·

SLIP warning light control.


Combination meter assembly Brake booster with master cylinder assembly (Skid control ECU) None Slip indicator illuminates. U0129
(Combination meter assembly)
HV Drive Guide Display
·

Displays EV conditions.


Combination meter assembly ECM EV condition display turns off. - U0100
(Combination meter assembly)
Anti-lock Brake System Control
·

Prevents the wheels from locking during sudden stops.


Brake booster with master cylinder assembly (Skid control ECU) Airbag sensor assembly (built-in type yaw rate sensor)
·

During control: When backup control (stabilizing the vehicle) is complete, the system changes to normal braking and prohibits control.

·

Not during control: Control cannot be performed.


·

Brake warning light (red) illuminates.

·

ABS warning light illuminates.

·

Slip indicator illuminates.

·

Brake warning light (yellow) illuminates.


U0073
U0123
U0124
(Brake booster with master cylinder assembly (Skid control ECU))
Vehicle Stability Control/Traction Control
·

Suppresses vehicle instability, such as sliding sideways when cornering and wheel slippage when accelerating from rest.


Brake booster with master cylinder assembly (Skid control ECU)
·

Hybrid vehicle control computer assembly

·

Airbag sensor assembly (built-in type yaw rate sensor)

·

Spiral cable with sensor sub-assembly (Steering sensor)


·

During control: When backup control (stabilizing the vehicle) is complete, the system changes to normal braking and prohibits control.

·

Not during control: Control cannot be performed.


·

Brake warning light (red) illuminates.

·

ABS warning light illuminates.

·

Slip indicator illuminates.

·

Brake warning light (yellow) illuminates.


U0073
U0123
U0124
U0126
U0293
(Brake booster with master cylinder assembly (Skid control ECU))
Hill-start Assist Control
·

Maintains the brake hydraulic pressure to the 4 wheels for 2 seconds with the brake pedal released when starting off on an uphill.


Brake booster with master cylinder assembly (Skid control ECU)
·

Hybrid vehicle control computer assembly

·

Spiral cable with sensor sub-assembly (Steering sensor)

·

Airbag sensor assembly (built-in type yaw rate sensor)


·

When control is being performed: Once control (depressurization control) has completed, further hill-start assist control is prohibited.

·

When control is not being performed: Hill-start assist control does not start.


·

Brake warning light (red) illuminates.

·

ABS warning light illuminates.

·

Slip indicator illuminates.

·

Brake warning light (yellow) illuminates.


U0073
U0123
U0124
U0126
U0293
(Brake booster with master cylinder assembly (Skid control ECU))
Hybrid Regenerative Operation
·

Regenerative cooperative control with the HV system.


Brake booster with master cylinder assembly (Skid control ECU)
·

Smart key ECU assembly (Certification ECU)

·

Hybrid vehicle control computer assembly

·

Airbag sensor assembly (built-in type yaw rate sensor)


·

When control is being performed: HV cooperative control is continued based on the latest value and gradually decreased. After this, HV cooperative control is prohibited.

·

When control is not being performed: HV cooperative control does not start.


·

Brake warning light (red) illuminates.

·

ABS warning light illuminates.

·

Slip indicator illuminates.

·

Brake warning light (yellow) illuminates.


U0073
U0120
U0123
U0124
U0293
(Brake booster with master cylinder assembly (Skid control ECU))
Vehicle Proximity Notification System
·

System which warns pedestrians, cyclists, etc. of the approaching EV/HEV vehicle by outputting an audible sound depending on various inputs such as vehicle speed, etc.


Vehicle approaching speaker controller
·

Brake booster with master cylinder assembly (Skid control ECU)

·

Main body ECU (multiplex network body ECU)

·

Hybrid vehicle control computer assembly


Vehicle approaching sound suspended. - U0129
U0140
U0293
(Vehicle approaching speaker controller)
Headlight Leveling Control (Headlight Control)
·

Adjusts headlights vertical aiming according to wheel speed and vehicle pitch angle determined using vehicle height sensor.


Headlight leveling ECU assembly
·

Brake booster with master cylinder assembly (Skid control ECU)

·

Main body ECU (multiplex network body ECU)


Headlight Leveling Control is stopped. - U0129
U0142
(Headlight leveling ECU assembly)