Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2019.07
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278195 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM U

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  TERMINALS OF ECU  


CHECK HEADLIGHT LEVELING ECU ASSEMBLY


E208529N12
3.406,0.156 3.781,0.385 0.375,0.229 3.479,0.198 4.115,0.396 0.635,0.198 10 false A34

a.

Disconnect the A34 headlight leveling ECU assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A34-1 (IG) - Body ground V - Body ground IG power supply Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
A34-9 (E1) - Body ground W-B - Body ground Ground Always Below 1 Ω


c.

Connect the A34 headlight leveling ECU assembly connector.


d.

Measure the voltage and resistance, and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A34-6 (CANH) - Body ground P - Body ground CAN communication line Power switch on (IG) Pulse generation
A34-7 (CANL) - Body ground W - Body ground CAN communication line Power switch on (IG) Pulse generation
A34-10 (RH+) - Body ground R - Body ground Headlight leveling motor RH power supply Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
A34-11 (LH+) - Body ground G - Body ground Headlight leveling motor LH power supply Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
A34-12 (SBR) - A34-21 (SGR) P - R Rear height control sensor sub-assembly power supply Power switch off Below 1 V
Power switch on (IG) 4.75 to 5.25 V
A34-17 (RHT) - Body ground G - Body ground Headlight leveling motor RH operation signal input With low beam headlights on, vehicle height not changed Below 1 V
With low beam headlights on, vehicle height changed and maintained for more than 3 seconds 1.0 to 14.4 V
A34-18 (LHT) - Body ground R - Body ground Headlight leveling motor LH operation signal input With low beam headlights on, vehicle height not changed Below 1 V
With low beam headlights on, vehicle height changed and maintained for more than 3 seconds 1.0 to 14.4 V
A34-19 (SHRL) - A34-21 (SGR) G - R Rear height control sensor sub-assembly signal input Power switch on (IG), vehicle unloaded, vehicle stopped Approximately 2.5 V
(value decreases as the front of the vehicle is raised)
A34-21 (SGR) - Body ground R - Body ground Rear height control sensor sub-assembly ground Power switch off Below 1 Ω
A34-23 (RH-) - Body ground L - Body ground Headlight leveling motor RH ground Power switch off Below 1 Ω
A34-24 (LH-) - Body ground L - Body ground Headlight leveling motor LH ground Power switch off Below 1 Ω