Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2019.07
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278195 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM D

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


Whenever an automatic headlight beam level control system DTC is stored, the headlight leveling ECU assembly stores the current vehicle state as freeze frame data.


CHECK FREEZE FRAME DATA


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.


e.

Select a DTC to display its freeze frame data.

Body Electrical > HL AutoLeveling
Tester Display Measurement Item Range Normal Condition Diagnostic Note
+B IG power supply voltage value 0.00 to 19.75 V 11.00 to 14.00 V -
Height Sens Pw Supply Val Rear height control sensor sub-assembly power supply value 0.00 to 5.00 V 4.61 to 5.00 V -
Rr Height Sens Signal Val Rear height control sensor sub-assembly signal value 0.00 to 5.00 V 0.50 to 4.50 V Value changes according to vehicle height
Headlight Low Beam State Low beam headlight state ON or OFF ON: Low beam headlights on
OFF: Low beam headlights off
-
Headlight High Beam State High beam headlight state ON or OFF ON: High beam headlights on
OFF: High beam headlights off
-
Front Right Wheel Speed Value Front right wheel speed 0.00 to 327.67 km/h (203.61 mph) Vehicle stopped: 0 km/h (0 mph) -
Front Left Wheel Speed Value Front left wheel speed 0.00 to 327.67 km/h (203.61 mph) Vehicle stopped: 0 km/h (0 mph) -
Vehicle Acceleration Vehicle acceleration -455.64 to 445.60 m/s2 Vehicle stopped: 0.0 m/s2 -
Number Of Trouble Codes Number of stored DTCs when Freeze Frame Data stored 0 to 255 0 to 255 -



CLEAR FREEZE FRAME DATA


NOTICE:

Clearing the DTCs will also clear the freeze frame data.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Clear the DTCs and freeze frame data.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Clear DTCs.